Ei Electronics Ei3105RF Manual do Utilizador

1SMOKE ALARMRadio WirelessInterconnectInstruction LeafletContains vital information on unit operation and installation.Read and retain carefully. If y

106.1 House Code ProcedureEnsure that the battery is connected to all alarms beforebeginning the house code procedure1. Pull cover open at tab. Press

117.1 Manually Testing your Smoke AlarmIt is recommended that you testyour Smoke Alarm at least weeklyto be sure the units are working. Itwill also

12If there are frequent nuisance/false alarms it may be neces-sary to re-locate the device away from the source of thefumes.If you installed the smoke

13the effects of contamination. However it is impossible to com-pletely eliminate the effect of dust and insect contamination,and therefore, to prolon

148.3 The alarms sound but the wireless interconnectiondoes not workThere are certain limitations on radio frequency signals (seesection 10.2) and s

15clean the Smoke Alarm following instructions in this leaflet.• In the United Kingdom Ionisation Smoke Alarms can be dis-posed of in normal household

164. Call the Fire Brigade from aneighbour’s house or mobile phone.Remember to give your name andaddress.5. NEVER re-enter a burning house.10. SMOKE A

17roll up fire ladders and stools without adult help. Make surethey know what to do if the alarm goes off.10.2 Limitations of Radio Frequency SignalsE

1812. FIVE YEAR GUARANTEE (Limited)Ei Electronics, guarantees this smoke alarm for five yearsfrom date of purchase against any defects that are due to

1914. TECHNICAL SPECIFICATIONBattery: Replaceable 9 Volt Alkaline Duracell (MN1604, Energizer 522 or Eveready 522). Battery Life:Battery can power un

Table of Contents1 READ THIS FIRST2 INTRODUCTION3 LOCATING YOUR SMOKE ALARMS4 POSITIONING YOUR SMOKE ALARM5 INSTALLING YOUR SMOKE ALARMS6 HOUSE CODING

20RF Visual Indicator: On Transmission, Amber LED lightscontinuously for 1.5 to 3.5 seconds while messages are beingtransmitted. Size of System: A max

21

22

23

24

310. If you have any doubt or query about Smoke Alarms con-sult the supplier or your local Fire Brigade.2. INTRODUCTIONCongratulations on purchasing E

4example) you should put your first Smoke Alarm in a corridoror hallway between the sleeping and living areas. Place it asnear to the living area as p

3.2 Multi Storey DwellingsIf your home has more than one floor, at least one alarm shouldbe fitted on each level (see figure 4). The Ei3105RF/Ei3100R

6entering the Smoke Alarm. Keep at least 0.30m away fromwalls and corners (see figure 5).4.2 Wall MountingWhen a ceiling position is not possible (

7It can also block the insect screen mesh and prevent smokefrom entering the chamber.• Do not locate in insect infested areas. Small insects gettingin

81. Pull cover open at tab. Remove cover from base by sepa-rating at rear snap-in hinges by rotating cover backwards.2. Place the base on ceiling or w

98. The units, as received, will transmit and receive the defaultRF signal. However, to avoid other neighbouring systemsinterfering with your alarms,